Steps to Achieve a Great Shine: Wet sand the Surface: Begin by sanding the entire tub or specific areas that need polishing. Use 1500-2000 grit wet or dry sandpaper, dip the sandpaper in water and sand the entire surface to level and remove any debris. Apply Compound: Before applying any compound, ensure the tub is dry. This will create a bubbly cleansing foam. Scrub the bubbling vinegar and baking soda into the stains and the surface of the sink, allowing it to sit for about 20 minutes. Then, rinse with cool clear water. If the stains remain, it is worth making a paste of baking soda water and allowing it to sit on the stain before attempting to scrub it again. Rinse with warm water afterwards. If there is any dried-on residue or hard-to-remove dirt, you can try a 50/50 solution of white vinegar and water and use it to scrub the ring. Rinse thoroughly and dry when finished. Lastly, use a wax or polish specifically for acrylic baths to maintain the shine of your bathtub ring. It's been a few years since we last talked about how to clean a bathtub, so in this video, that's exactly what we are doing! Cleaning Expert Melissa Maker sh Step 3. Apply a Thick Layer of Paste: Create a thick layer of paste by mixing paint stripping chemicals with sawdust or sand in a jar or plastic container. This paste should then be applied over the dried epoxy paint in an even layer and left for at least half an hour to sit. Step 4. Scrape Away Paint: . Dampen the tub with hot water. Sprinkle baking soda liberally all over the tub. Spray a 1:1 mixture of distilled white vinegar and water on the baking soda. Use a sponge to rub the solution into the tub until it gets pasty. Let the cleaning solution sit for 20 minutes. Rinse the tub with hot water and check the stains. Strip off caulk. Scour tub clean and scrape with a razor blade. Repair cracks and chips with a filler. Sand tub with an electric orbital sander fitted with #120-grit sandpaper. Thoroughly clean tub. Use an airless paint gun to spray two to three coats of refinishing paint on the bathtub. Re-caulk the tub. A healthier way to remove dirt and grime and keep the bathtub clean is to use more natural products. Use a vinegar solution. One of the best ways to clean the bathtub, caulk, and grout is with a vinegar solution. In a spray bottle or bucket, combine 1 part vinegar to 9 parts of water. The caulk remover works by destroying the bond between the caulk and the tub or tile, so that instead of chipping at the caulk with a razor blade, you just pull away big chunks of it with a putty knife. Most removers work on both silicone and acrylic latex caulks. Clean off the residue with soap and water, let dry and then recaulk. Hey Guys, welcome back to another video. Today I will be showing you how to clean your bathtub using Dawn dish soap and Vinegar. I saw this on YouTube and Pi

how to clean acrylic bathtub